I just wanted to write you a note telling you how your Flex-Bit worked for me. We had a little different application. We are building a Hydro Electric plant in Hawesville KY. Hydro Plants have what is called a draft tube which helps accelerate water on the way out of the power house. So the form work is designed and built in cylinder shape. With massive pours the form work was huge and being on a radius made drilling tie holes in place a necessity. Some locations we were drilling 6 ft through the form work at an angle because of the radius. However do to the design of the tip of your bit it had no problem getting started drilling the hole. I had already tried several other types of bits when I found yours and I’m pleased to tell you it was awesome. It stayed sharp for many holes no problems with points or the shafts Worked out very well. Thank you for a great product very useful in unusual situations we use it for all kinds of different things now that we have some.

Great! Stated it was made in the USA. Drilled no problem through double plates, flexes in tight spots, bites where you put it, flexes without breaking (backoff and go forward again). Really got me out of some tight spots through the attic to get down to the plates due to a vaulted cieling (needed to get a bit down a tight gap to a double plate).

I was recently doing repairs on a very expensive pumping unit, and I needed to raise unit slightly for reassembly. I used the Winbag and was able to raise the unit to the appropriate height and hold it there while I assembled the unit. Great product, check out the photo and you can see the Winbag in action! It made my job so much easier, thanks Eagle Tool for such a great product!

Thank you for a great product very useful in unusual situations we use it for all kinds of different things now that we have some.